![]() Follow the wizard to finish the process.Only drives that meet the type and capacity requirements will be listed. Select the drive you want to add from the list.Click Add Drive from the Action drop-down menu. Go to the Storage Pool page and select the storage pool you want to expand.Power on your $_DSPRODUCTNAME_$ and launch Storage Manager.At Documents > Hardware Installation Guide, you can download the hardware installation guide of your preferred language to follow the drive installation instructions. Note: To avoid harming yourself or damaging your $_DSPRODUCTNAME_$, please go to Download Center and select your Synology product. Insert a new drive into an empty drive slot.Note: Skip this step if your $_DSPRODUCTNAME_$ supports hot-swapping. Afterward, follow the steps below to add a drive to a storage pool: If the storage pool status is not healthy, please follow the recommended actions shown beneath the status to fix drive issues. Using incompatible drives may lower the system performance and even cause data loss.īefore you start, make sure the status of the storage pool you intend to expand is Healthy. We recommend using drives in the Synology Products Compatibility List to prevent any issues.Please visit here to check if your model supports RAID F1. RAID F1 is available on specific models only.Please visit here to check if your model has limited support for SHR. SHR (Synology Hybrid RAID) is available on specific models only.Example: If a RAID 5, RAID 6, or RAID F1 storage pool is composed of three drives (2 TB, 1.5 TB, and 1 TB), then the capacity of the new drive must be at least 1 TB. For RAID 5, RAID 6, or RAID F1: The capacity of the drive you intend to add must be equal to or larger than the smallest drive in the storage pool.You can consider adding 1.5 TB and 1 TB drives, but please note that some capacity of the 2 TB drive will remain unused. Example: If an SHR storage pool is composed of three drives (2 TB, 1.5 TB, and 1 TB), we recommend that the newly-added drive should be at least 2 TB for a better capacity usage. For SHR: The capacity of the drive you intend to add must be equal to or larger than the largest drive in the storage pool, or equal to any of the drives in the storage pool.4K native drives and non-4K native drives.Mixed drive types as shown below are not supported for RAID or SHR configuration: Using drives of different types will affect system reliability and performance. ![]() RAID or SHR configuration must be created by drives of the same type.Please make sure the drives that you intend to add to your $_DSPRODUCTNAME_$ meet the following requirements: The status of the newly-added drive must be Initialized or Not Initialized. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |